Thursday, December 3, 2009

How to change a hard drive

One of the most frustrating computer components that can fail, the hard disk or hard disk unless you are one of the sages, who has learned to back up your data regularly is good, you lose everything.

A hard disk or hard drive, an internal component that is installed in your computer, and is the place where all your files and folders, and your operating system is stored. Without hard drive of your PC will not work. If you have bad luck, for your hard drivedo not read, then learn how to change it for a new one.

In general, if a hard drive will fail, it is unlikely that all work cease, without any warning. Often, clicking sounds, periodic alerts, or your system regularly crashes at irregular intervals. Note that, apart from the clicking sound, the other symptoms could well be, in fact, several computer hardware or software problems other than the hard drive

If you are surethat your disk is to blame, then you need to get a replacement drive. In a desktop PC, this is a relatively simple process - with a laptop or notebook computer, it is probably more ideal to the specific conditions of the manufacturer, speak with the first manufacturers.

First, you need to figure out what type of disk you are currently using. There are two types or hard drive - PATA and SATA. SATA drives are fairly new, so if your computer is a few years old then it is quitewill probably not SATA. PATA is more common in older machines and has the typical 4-pin connector along with the standard IDE cable - the same cable type to a standard CD / DVD-ROM drive connects. SATA connectors are are much smaller - almost one third the size of the IDE connector.

If your SATA drive then you just need the job done and connectors, PATA, please check whether the setting of the drive is Master mode - this is usually done by a small bridge to the pins on the doneEnd. There is usually a chart on the pins you need to illustrate the bridge. In general, most will come factory-set as master.

After the type of drive you need, then you have to go out and buy the drive yourself confirmed. Here you will find more options on the connection you can choose from. Speed and buffer size, and of course great. The faster speed hard drive with the largest buffer that you can afford it, it is recommended that. In addition, of course,the size, is one's own personal choice, but go rather than reduced. Most of the time for an average user, the smallest of the drives offer plenty of space.

If your hard drive, you should turn off the device to the computer and disconnect all cables purchased. Remove the control panel of the case and clean the dust in your machine. Carefully remove the existing hard drive from its mounting plates. This rule by loosening screws computer cases do, but reached. vary

With your new hard drive now installed, you need to reinstall your operating system - that is, ideally by a recovery CD, but not when a copy of your preferred operating system and license key is required to be achieved .. Prepared this take some time for loading.

If you lost valuable data from your hard drive otherwise it may be possible to restore some or all of these data. Take it to someone who knows what they are doing here.

No comments:

Post a Comment